|
Material Safety Data Sheet for Ascor L 500

SECTION 1.
CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name:
Ascor L 500®
Synonyms:
Ascorbic Acid Injection - USP, Vitamin C, Sodium Ascorbate
Manufacturer:
McGuff
Pharmaceuticals, Inc.
2921 West McArthur Blvd, Suite 141
Santa Ana, CA 92704
Revision Date:
August 4, 2003
Information
Telephone Number: (714) 918-7277
Fax number:
(714) 438-0520
Emergency
Telephone Number: (714) 918-7277
CHEMTREC:
1-800-424-9300 CANUTEC: 613-996-6666
SECTION 2. COMPOSITION,
INFORMATION ON INGREDIENTS
Chemical Ingredients:
| Component |
CAS Number |
| Ascorbic Acid,
500mg/mL |
50-81-7 |
| Edetate Disodium |
139-33-3 |
| Sodium Bicarbonate |
144-55-8 |
| Water |
7732-18-5 |
SECTION 3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Remove any contamination from the skin,
eyes, or clothing.
POTENTIAL HEALTH EFFECTS
Inhalation:
Not expected to be a health hazard via
inhalation.
Ingestion:
Not expected to produce any acute
adverse health effects. Large doses may cause gastrointestinal upset.
Skin Contact:
Not expected to produce any acute
adverse health effects.
Eye Contact:
No adverse effect expected, but may
cause mechanical irritation.
Chronic Exposure:
Not expected to be a chronic health
hazard.
Aggravation of Pre-existing
Conditions:
No information found.
SECTION 4. FIRST AID MEASURES
Inhalation:
Not expected to require first aid
measures.
Ingestion:
If large amounts are swallowed, give
water to drink and seek medical attention.
Skin Exposure:
Wash exposed areas with soap and water.
Get medical advice if irritation develops.
Eye Exposure:
In case of contact, immediately flush
eyes with running water for at least 15 minutes. Get medical advice if
irritation develops.
SECTION 5. FIRE FIGHTING MEASURES
Fire: Not considered to be a fire
hazard.
Explosion: Not considered to be
an explosion hazard.
Fire Extinguishing Media: Use any
means suitable for extinguishing surrounding fire.
Special Instructions: In the
event of a fire, wear full protective clothing and NIOSH-approved
self-contained breathing apparatus with full facepiece operated in the
pressure demand or other positive pressure mode.
SECTION 6. ACCIDENTAL RELEASE MEASURES
Collect all spills and dispose of as
non-hazardous waste. All cleanup operations should be performed according to
the Standard Operating Procedures (SOPs) established for your facility and
applicable local, state or federal regulations.
SECTION 7.
HANDLING AND STORAGE
Store at 2oC to 8oC.
Pressure may develop within the vial upon long storage. Precautions should
be taken when product is being withdrawn from vial. Internal pressure may
expel plunger from syringes and other devices upon insertion into the
stoppered vial. Storage and disposal of product should be controlled in a
manner which is in compliance with the appropriate regulations of the
federal or state government agencies.
SECTION 8. EXPOSURE CONTROLS, PERSONAL
PROTECTION
Airborne Exposure Limits:
None established.
Engineering Controls:
Not expected to require any special
ventilation.
Respiratory Protection:
Not expected to require personal
respirator usage.
Skin Protection:
Wear protective gloves and clean
body-covering clothing.
Eye/Face Protection:
Safety glasses.
SECTION 9. PHYSICAL AND CHEMICAL
PROPERTIES
Appearance: Clear, colorless to
slightly yellow liquid.
Odor: Odorless. May have a
slight salt odor.
Solubility: Soluble in water.
SECTION 10. STABILITY AND REACTIVITY
Stability: In the dry state, it
is reasonably stable in air, but in solution it rapidly oxidizes.
Hazardous Decomposition Products:
When heated to decomposition, ascorbic acid emits acrid smoke and irritating
fumes.
Hazardous Polymerization: Should
not occur.
Incompatibilities: No information
found.
SECTION 11. TOXICOLOGICAL INFORMATION
Ascor L 500® is for
formulated to contain various base ingredients as listed in section 2.
Toxicological information on specific components may be obtained by
submitting a written request to McGuff Pharmaceuticals, Inc. at the address
listed in Section 1 - Attn: Customer Service Department.
Ascorbic Acid (dry powder): LD50
(IV-mouse) 518mg/kg
SECTION 12. ECOLOGICAL INFORMATION
Ascor L 500® is intended for
use by hospital or pharmacy professionals, it is expected to be treated by
standard wastewater treatment facilities with no adverse environmental
impacts.
SECTION 13. DISPOSAL CONSIDERATIONS
Ascor L 500® is considered
non-hazardous. Consult local, state and federal regulations for proper
disposal.
SECTION 14. TRANSPORT INFORMATION
DOT (Department of Transportation):
Not Regulated
SECTION 15.
REGULATORY INFORMATION
CERCLA Reportable Quantities:
None.
SARA Title III
302 Extremely Hazardous Substances: None
311/312 Hazard Categories: None
313 Toxic substances subject to annual
release reporting requirements: None.
RCRA Hazardous Waste Status
Non-hazardous (See Section 13 for
additional details.)
California Proposition 65 Warning
This product does not contain substances
known to the State of California to cause cancer.
Australian Hazchem Code: None
allocated.
Australian Poison Schedule: None
allocated.
WHMIS: This MSDS has been
prepared according to the hazard criteria of the Controlled Products
Regulations (CPR) and the MSDS contains all of the information required by
the CPR.
SECTION 16. OTHER INFORMATION
MSDS Status: Revised in
accordance with ANSI Guideline Z400.1-1998
NFPA Ratings: Health: 0
Flammability: 0 Reactivity: 0
Product Use: Refer to package
insert supplied with product for detail use information. Generally, Ascor L
500 is a solution of Ascorbic Acid (Vitamin C) in Water for Injection
intended for use in hospital or pharmacy admixture operations.
Revision Information: No changes.
McGuff Pharmaceuticals provides the
information contained herein in good faith but makes no representation as
to its comprehensiveness or accuracy. This document is intended only as a
guide to the appropriate precautionary handling of the material by a
properly trained person using this product. Individuals receiving the
information must exercise their independent judgment in determining its
appropriateness for a particular purpose. The information published in this
Material Safety Data Sheet has been compiled from data in various technical
publications. It is the user’s responsibility to determine the suitability
of this information for adoption of necessary safety precautions. We reserve
the right to revise Material Safety Data Sheets as new information becomes
available. Copies may be made for non-profit use.
MCGUFF PHARMACEUTICALS, INC. MAKES NO
REPRESENTATIONS OR WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING WITHOUT
LIMITATION ANY WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE WITH RESPECT TO THE INFORMATION SET FORTH HEREIN OR THE PRODUCT TO
WHICH THE INFORMATION REFERS. ACCORDINGLY, MCGUFF PHARMACEUTICALS, INC.
WILL NOT BE RESPONSIBLE FOR DAMAGES RESULTING FROM USE OF OR RELIANCE UPON
THIS INFORMATION. |